无锡科达脚手架厂【官网】主营:脚手架、移动脚手架、门式脚手架、梯形脚手架

无锡科达脚手架厂

示例图片三
网站首页 > 新闻资讯 > 时事新闻

电热风炉发生火灾的原因及解决办法

2019-02-21 14:27:23 无锡科达脚手架厂 阅读

热风炉主要就是以空气为热载体,运用了电加热装置,能够为各类干燥设备还有暖通行业供应高温洁净热风,是属于种高效率并且节能的供热设备。下面由上海杰门热风炉厂家跟你们介绍下电热风炉出现火灾的原因还有应该怎么处理。
Electric stove is a kind of high-efficiency and energy-saving heating equipment, which mainly uses air as heat carrier and uses electric heating device to supply high-temperature clean hot air for all kinds of drying equipment and HVAC industry. Below by Shanghai Jiemen hot stove manufacturer to introduce to you under the electric hot stove fire causes and how to deal with. 一、电热风炉发生火灾的原因有:
1. The causes of fire in electric stove are as follows:

1、把通电电热风炉放在容易燃的物品上或者是放在容易燃烧物的附近,在长期高温的烘烤下而导致火灾的出现。
1. Put the electrified electric stove on the combustible materials or near the combustible materials, which will lead to the emergence of fire under the long-term high-temperature baking.

2、电热风炉没有安装插头,而是直接把电线头插在插座中,所以容易导致短路而出现火灾。
2. The electric stove does not install plugs, but directly inserts the wire head into the socket, so it is easy to cause short circuit and fire.

3、使用者在离开时未将电热风炉的插头拔去,时间过长,造成电热风炉过热,将邻近的可燃物引燃而造成火灾。四是电阻丝多次修理后继续使用,可造成线路过负荷而引发火灾。
3. The user did not remove the plug of the electric stove when he left, and the time was too long, which caused the electric stove to overheat and ignited the nearby combustibles and caused a fire. Fourth, the resistance wire will continue to be used after many repairs, which can cause line overload and fire.


二、电热风炉失火的解决预防办法:
2. Solutions and precautions for electric stove fire:

1、导线必须安装插头,不可将线头直接插入插座;电热风炉导线老化破损应及时更换,电路中没有安装熔断器的电热风炉不得使用。
1. The wire must be plugged in, and the wire head should not be inserted directly into the socket. The wire aging and breakage of the electric heater should be replaced in time, and the electric heater without fuse in the circuit should not be used.

2、电热风炉在使用工作的时候一定是有人看管,在离开的时候需要拔掉插头,在使用它工作的时候,如果出现停电,也是需要及时把插头拔出,一定不可以遗忘。多次修理的电阻丝,建议不要再去使用,需要更换新电阻丝。电热风炉一定要放在不导热并且不燃材料的基座上。
2. The electric stove must be taken care of when it is in use and working. When it leaves, it needs to unplug the plug. When it works, if there is a power failure, it also needs to unplug the plug in time. It must not be forgotten. Repeated resistance wire, it is recommended not to use again, need to replace new resistance wire. The electric stove must be placed on the base of non-conductive and non-combustible materials.

3、电热风炉的导线安全截流量一定要是能够满足电热风炉容量的需求,工业用电热风炉在任何状况下都是需要安装单独的电路。
3. The safe cut-off flow of the electric stove's conductor must be able to meet the demand of the electric stove's capacity. The industrial electric stove needs to install a separate circuit under any condition.


标签:   热风炉 脚手架 移动脚手架 梯形脚手架 门式脚手架 脚手架厂家