无锡科达脚手架厂【官网】主营:脚手架、移动脚手架、门式脚手架、梯形脚手架

无锡科达脚手架厂

示例图片三
网站首页 > 新闻资讯 > 时事新闻

长时间运用养殖热风炉的几个原因

2019-02-21 14:28:50 无锡科达脚手架厂 阅读

为什么现在取暖设备尤其是养殖热风炉销售量那么好,给大家说四个优点之处就能让大家了解到为什么一直以来养殖热风炉那么受欢迎。当今现在养殖暖风炉事故频发,那么究竟是什么引起的养殖暖风炉事故呢?当养殖暖风炉在运行时,又是什么引发的事故呢?
Why is the sales volume of heating equipment, especially the breeding hot stove so good now? Give you four advantages, we can let you know why the breeding hot stove has been so popular all the time. Nowadays, there are frequent accidents of breeding heater, so what exactly caused the accident of breeding heater? When the breeding heater is in operation, what caused the accident? 一、汽水共腾
I. Steam and water co-effluent

1.汽水共腾特点就是:水位表的水位强烈波动并且锅中水起泡,蒸汽当中含有大量的水,蒸汽的温度降低,严重的话会导致管道中发生水冲击。
1. Steam-water co-effervescence is characterized by strong fluctuation of water level of water gauge and bubbling of water in pot. Steam contains a large amount of water, and the temperature of steam decreases. Seriously, water impact will occur in pipeline.

2.产生这种状况的原因就是因为:水质不良,具有的盐量太高或着是养殖暖风炉负荷增加过急等。
2. The reason for this situation is that the water quality is not good, the salt content is too high or the load of the breeding heater increases too quickly.

3.发现汽水共腾的时候,一定要加强水质处理以及加大连续排污。
3. When it is found that soda and water co-evaporate, we must strengthen water quality treatment and increase continuous sewage discharge.

二、炉管爆炸
2. Furnace Tube Explosion

1.炉管爆破的时候,有显著的爆破声、喷汽声,同时,水位和汽压明显下降。发现这种情况时,必须采取紧急停炉处理措施。
1. When the furnace tube is blasted, there are remarkable blasting sound and steam injection sound. At the same time, the water level and vapor pressure decrease obviously. When this situation is found, emergency shutdown measures must be taken.

2.发生这种情况的一般原因是:水质不良引起炉管结垢或腐蚀,缺水和爆管也可能互为因果。
2. The common reason for this is that poor water quality causes scaling or corrosion of furnace tubes, and water shortage and tube bursting may cause and effect each other.

3.此外,由于设计缺陷、材料强度不足和焊接质量不好,均可能引起爆管事故。
3. In addition, due to design defects, inadequate material strength and poor welding quality, tube explosion accidents may occur.


三、锅炉超压
3. Boiler Overpressure

1.养殖暖风炉超压运行,轻则引起元件变形,边续处损坏,严重时会引起事故。
1. Overpressure operation of the breeder heater will cause component deformation and damage at the edge, and accidents will occur in serious cases.

2.发生养殖暖风炉超压的主要原因是:司炉人员盲目提高工作压力或擅离工作岗位造成的。
2. The main reasons for the overpressure of breeding warm stove are that the fireman blindly raises the working pressure or leaves his post without permission.

3.有时,由于压力表和安全阀同时失灵也会引起锅炉超压,因此,必须加强司炉工岗位责任制和对安全附件的检查。
3. Sometimes, due to the pressure gauge and safety valve failure at the same time will also cause overpressure of the boiler, therefore, it is necessary to strengthen the responsibility system of the furnace manager and the inspection of safety accessories.

四、锅炉缺水
IV. Boiler Water Shortage

1.养殖暖风炉如果严重缺水的时候,这样会导致受压元件变形或者是损坏,还有会发生炉管爆炸,假如处理不当的话很有可能会出现燃气锅炉爆炸的事故。
1. If there is serious water shortage in the breeding heater, it will lead to deformation or damage of pressurized components, and there will be tube explosion. If improperly handled, gas boiler explosion is likely to occur.

2.如果发现燃气锅炉缺水的时候,需要严禁进水,然后采取停炉的措施。
2. If it is found that the gas-fired boiler is short of water, it is necessary to strictly prohibit water intake, and then take measures to stop the boiler.

3.造成养殖暖风炉缺水事故的原因大多与运行人员松懈麻痹和误操作有关,或是与水位表因无冲洗措施而发生堵塞故障有关。
3. Most of the causes of water shortage accidents in breeding heaters are related to slack, paralysis and misoperation of operators, or to blockage failure of water gauges due to no washing measures.


标签:   脚手架 梯形脚手架 门式脚手架 热风炉 脚手架厂家 移动脚手架